12-Volt DC Electric Winch, 3000 lb. Single Line Dead Weight Lift, 25' x 7/32" Cable

When arm strength simply isn't enough, look no further than the Dutton-Lainson StrongArm® electric winches to get the job done. Dutton-Lainson electric winches come standard with power in, power out, controlled freewheeling clutch, automatic braking, and an emergency manual crank handle in case of power loss. The 12-volt electric winch can be powered through your car vehicle battery using the included wiring harness (25' positive battery wire, 8' ground wire). Winch includes a high-torque 12-volt DC motor with circuit-breaker overload protection. This 12-volt DC electric trailer winch also includes electric switch and clutch controls conveniently located on the same side for easy operation, while the clutch lever allows for smooth load control and easy cable removal. 25 feet of 7/32" galvanized aircraft cable with snap hook allows heavy-duty single-line horizontal towing up to 3,000 lbs.

The covered, compact design enables these electric cable winches to be installed in tight spaces and protects the winch cable and other internal components from rust, wear, and outdoor elements. Perfect for boat trailers, car trailers, loading docks, overhead doors, industrial trucks, farm applications, and commercial mechanic shops—StrongArm® electric winches are made for a wide array of your pulling or lifting applications.

Note: This winch is built for horizontal pulling applications for a maximum consistent run time of 4 minutes.

The winch gear train uses heat-treated sintered iron gears to provide smooth, quiet operation and final drive gears are heattreated high carbon steel for maximum strength. Light-load bearings are permanently lubricated sintered iron, and precision needle bearings are used in the high load areas for low friction and long life. The heavy gauge steel one piece die-formed base has three keyhole mounting slots for use with quick mounting shoulder studs. The chrome plated heavy-gauge steel front frame protects the cable from abrasion. A formed spring steel plate insures level winding of cable onto the reel.