Mechanical Lever

The Lever Switch is actuated by a float ball or cylinder that is attached to a rod. When water rises or drops, the float adjusts with the water level until it hits a preset float stop on the rod. The float stops are simply screwed to the rod. Once the float hits a stop, the mechanical lever switch turns the pump on or off – depending upon whether the stop is either at the high level or low level.
HP Ratings are for direct motor control. 115V can be ran up to 2HP Max & 230V can be ran up to 3HP Max. Float Options listed below are NEMA Type 1. Call for Options in NEMA Type 4 or Type 7. 3 Phase Power must use a control panel – cannot run direct motor control. Designed for Easy Installation and removal through 6-1/4" hole in the wet well cover.

Includes:

• Two pole float switch
  
• Stainless steel float rod
  
• Guide for float rod
  
• Stainless steel float
  
• Adjustable brass stops
  
• Pedestal assembly with bottom plate. Plate mounts over the lever control hole in the wet well cover.

Duplex & Other Simplex Options Available Upon Request Call With Systems Specifications