Roller Pump, 6-Rollers, Cast Iron, 3/4" Ports, CW (Reverse) Rotation

An extremely versatile pump despite low cost. Available in Ni-Resist, Cast Iron and Silver Cast® construction. Equipped with Viton® seals, sealed bearings. Maximum Temperature is 140 Deg. F. Metallic rotor. Weight is 9 lbs.

Max RPM: 1200
Shaft: 5/8" O.D.
Seals: Viton
Pump Shaft Rotation: CW or CCW when facing shaft
Capacity: to 21 GPM
Max Pressure: 150PSI
Super Rollers
Use 1" Suction Line at speeds above 800 RPM.

These roller pumps are used mainly in agriculture, park and turf management and pest control. They operate efficiently at tractor PTO speeds, will handle suspensions of non-abrasive wettable powders and will tolerate considerable wear before performance is adversely affected.

Body: Cast iron, Ni-Resist or Silver Cast®.
Seals: Viton® is standard on 1700, 4000, 6500 and 7560 Series. Buna-N is standard on the 1500 series.
Shafts: are all of Stainless Steel.
Rollers: These pumps are all supplied with a complete roller of Nylon & Polypropylene. Teflon and Buna-N rollers are available for specific applications.

XL Silver Cast® Pumps from HYPRO
Silver Cast is a new alloy developed by Hypro which is harder, wears better and is more corrosion resistant than any other casting material used in Ag Roller Pumps. These pumps will outlast cast iron models by 10 times. Use on Round-Up™ type products.

Viton® is a registered trademark of DuPont Performance Elastomers